TIC Speaker TFS0 User Manual

TFS0, TFS5 Outdoor Rock Speakers Models  
TFS0 rock speaker pair  
TFS5 rock speaker pair  
TIC TFS4 & TFS5 Outdoor Rock Speakers Feature  
Weatherproof Design  
Unlike other rock speakers  
2x unique shaped rock speakers  
included per pair  
Full range 100W drivers  
5” co-axial drivers  
1” aluminum tweeters  
Surge protected Revchem®  
Teflon® sealed  
8 Ohm Impedance  
Aerospace grade multi-layer  
composite cabinetry  
Finishes: Canyon (CN) Slate  
(SL) or White Granite (WG)  
©TIC Corporation U.S.A.  
 
Index…  
Introduction ………………….……………  
Component List …………………….…….  
Pre-Installation …………………… ……..  
Connection Cable ……… ……………....  
3
4
4
5
Exterior Installation ……………………… 5/6  
Maintenance ………………………………  
Customer Service ………………..………  
Warranty …………………………..………  
Trouble Shooting ……...…………….…...  
7
7
7
9
Technical Specifications …………….….. 10  
Thank You for purchasing another high quality audio  
product from TIC Corporation. Please read the enclosed  
installation guidelines carefully and thoroughly to ensure  
years of trouble free service from your new TIC exterior  
audio products.  
Carefully unpack your new TIC exterior product and  
save all packaging materials for possible future use. Check  
that your new TIC product contains all system parts  
detailed in the Components list. Do not attempt to operate,  
install or use your new TIC product if any components  
appear missing or damaged. If so, please notify TIC  
Corporation or your TIC Dealer as soon as possible.  
!WARNING! to avoid possible suffocation or injury please  
keep all plastic bags away from children and pets.  
 
Component List…  
2x  
2x  
Outdoor rock speakers  
Weatherproof speaker cable  
connectors (base of units)  
New product offer (enclosed  
with literature)  
1x  
1x  
1x  
Instruction Manual  
Warranty Card  
Pre-Installation…  
Need Professional Help?  
Please read this owners guide carefully before installation. Failure to follow  
these instructions fully or incorrect installation may damage your new TIC  
products and any third party equipment used in your new system installation.  
This may also Void any warranty for your new TIC products. If you are unsure  
of your ability to fully understand and fully complete the installation of this TIC  
product, please consult a professional installer.  
Note: TIC Corporation always recommends that you test your product and its  
components prior to exterior installation. Test your components near a mains  
power and, if required, receiver amplifier source somewhere convenient,  
perhaps inside. Ensure all components are working smoothly and correctly  
before exterior placement and operation.  
 
Exterior Installation…  
Before you begin the installation of your new TIC outdoor product, please  
carefully select the locations of your new TIC products.  
In general;  
1. Select a reasonably level surface for the installation of your new TIC  
outdoor speakers. For surface speakers this will prevent movement or  
excessive vibration during use. This will also ensure more uniform  
sound dispersion.  
2. Ensure your new TIC outdoor speaker cables or power source if  
required, can easily reach your new speakers. Some people even pre-  
lay string as a guide ensuring that there are no obstructions or  
difficulties such as concrete paths or architectural feature impediments.  
While most if not all TIC outdoor speakers use and recommend burying  
the cable lightly 4-6 inches, if the cable is surface mounted you must  
make sure the cable is placed where it cannot be tripped over, pulled,  
abraded or crushed.  
3. Do not place your TIC outdoor speakers in a depression or area where  
water pools or in the direct path of sprinklers.  
4. Wherever possible avoid long term exposure of your new TIC outdoor  
speakers to chlorinated solvents, acids such as those often contained  
in fertilizers and other solvents which have the potential to eventually  
wear the components prematurely.  
5. When installing either burial cable or TIC’s in-ground outdoor speakers  
please be very aware of any submerged plumbing, piping such as  
sprinklers or irrigation and wiring already in existence.  
A note on Speaker Cable;  
TIC recommends the use of our SPC double insulated high quality speaker  
cable, however just about any reasonable speaker cable may be used including  
existing runs that may be in place. For standard 8 installations of 10 – 25ft.,  
just about any 16/18 gauge 2 core cables can usually be used although we  
would prefer a double insulated or burial spec cable be used. For longer runs of  
25 – 100ft. 10/14 gauge cable can be used however resistance down the line  
will become a contributing factor.  
Please visit TIC Corporations website at www.ticcorp.com and review the  
Audio Installation Basics articles under Technical Resources for more in depth  
exterior audio and cable guidelines.  
 
Before actually sinking the cable, run the cable from your unit to the power  
source or amplifier. Ensure your cable run avoids any obstacles such as  
sunken sprinkler pipes or piping and electrical cable to your house. Once the  
cable runs are where you like them, connect your speakers and power source  
to ensure correct operation before sinking the cable. Disconnect the cable wire  
at both ends and continue.  
An Important note on Polarity!  
Pleasure proper polarity when connecting your new TIC outdoor speakers.  
This is very important and will result in poor sound reproduction and possibly  
equipment damage if not connected correctly. This is normally avoided by  
ensuring + to + and – to – or as sometimes color coded Red to Red and Black  
to Black from your amplified source to your speakers respectively.  
Once you have tested your cable run in step 3, it is time to sink the cable. 4-6”  
of cover is normally recommended to offset accidental disturbance, movement  
of the earth etc. but your specific onsite conditions will apply. Should you wish  
to secure the installation of your unit then simply clamp, by way of a “U” spike  
etc. the cable directly beneath the unit or you may use TIC’s SPPSS Security  
Stake available as an optional extra.  
Reconnect the speakers and your receiver amplifier being careful to ensure  
correct “Polarity” matching.  
 
Once connected properly, fill in all trenches, sit back and enjoy!  
Disclaimer;  
TIC Corporation will in no way be held responsible for the improper or  
unsecured installation of this product. Any and all damage arising from the  
installation or use of this product is the purchaser and final installer’s sole  
responsibility.  
Maintenance…  
Occasional maintenance of your TIC products cannot hurt and may help  
greatly. Inspect the installation area regularly removing and twigs, dirt or  
particulate matter from impeding or building up around the output grill area. The  
units may be cleaned using very mild detergents like dishwashing liquid if  
desired. A hose with clean water may also be used but please avoid using high  
pressure or forcing water into the grill or acoustic ports.  
In very cold climates with moderate to heavy snowfall an old trick from the  
major theme parks we supply world wide is to place a plastic bag over the unit  
for the winter or periods it may be not in use or under such snowfall.  
Customer Service…  
For any additional help please contact TIC Corporation at (800) SPX-OMNI, on  
line at www.ticcorp.com , or by email at [email protected] where we would be  
happy to assist you at any time. Also please visit our website for FAQ  
(frequently asked questions) and full contact information.  
Warranty Period…  
TIC Corporation offers a full, UCC approved, one year full parts and labor  
warranty on all its products as standard however there are other 3 and 5 year  
warranties in use with various TIC authorized Dealers world wide. Please check  
your enclosed Warranty card or your Dealer receipt to find out which one  
applies to you. Also please note TIC Corporation General Terms & Conditions  
posted on our website at www.ticcorp.com for further information.  
 
Installation Notes…  
 
Trouble Shooting…  
Problem  
Please Check  
Check the speakers are connected to the cable  
correctly.  
No Sound  
Check the speaker cable is connected to the receiver  
amplifier correctly.  
Check the receiver amplifier is powered “on” at the  
mains, is not on “mute”, has no headphones attached  
and that the Channels used for the exterior speakers  
(usually A or B) is in operation.  
Refer to the owners guide that came with your  
receiver amplifier.  
Most initial problems are connectivity, please try a  
different connection cable to your outdoor speakers  
or equipment.  
Check the “balance” control on your receiver  
amplifier.  
Check all connections and cable to the inoperable  
speaker.  
No Sound from one  
speaker  
1. Disconnect the “working” speaker from the  
receiver amplifier connection/ channel. Switch the  
cord from the non-operating speaker from its current  
connection to the “working” speaker connection. If  
the speaker now works the problem is your receiver  
amplifier.  
2. Reconnect as original. Remove the speaker cable  
at the “working” speaker directly and connect it  
directly to the non-working speaker. If the speaker  
now works the problem is somewhere in the original  
speaker cable.  
3. If the speaker still does not work the problem is the  
speaker.  
One speaker sounds  
distorted, lower  
Follow same procedure as above for “No Sound”.  
volume or “different”  
Check the “tone” setting on your receiver amplifier.  
Adjust the Treble and Bass settings on your receiver  
amplifier.  
Treble or Bass  
Check the connections carefully from the amplifier to  
your speakers and ensure correct Phase (+ to + and  
– to – accordingly). Poor sound replication is  
expected from a speakers or speakers out of polarity  
or phase.  
 
Technical Specifications…  
General Specifications TIC TFS0, TFS5  
Outdoor Rock Speakers  
Speaker Drivers 2x full range Co-Axial Drivers  
2x 5" injection molded PP cone  
Woofer(s)  
Butyl rubber surround  
Tweeter 2x 1" aluminum  
Cabinetry Multi-layer Composite  
Grill Multi-layer Composite  
Frequency Response 77Hz – 19kHz  
Sensitivity @1W/1m 84db ± 3db  
Continuous/ Peak 50 / 100W  
TFS0: 8x10x9in  
Unit(s) Dimensions  
TFS5: 8.2x8.5x9.5in  
TFS0: 6 Lbs  
Unit(s) Weight  
TFS5: 6.5 Lbs  
TFS0: 9x9.7x19in  
Pack Dimensions  
TFS5: 9.4x18x9.3in  
TFS0: 13.5 Lbs  
Pack Weight  
TFS5: 15 Lbs  
TIC Corporation engages in continual product research and development, new  
materials, production methods and design improvements. TIC Corporation therefore,  
reserves all rights to change or improve products specifications without notice.  
TIC Corporation  
15224 East Stafford Street  
City of Industry, CA. 91744-4418 U.S.A.  
Tel: (800) 779-6664 (5 lines) Fax: (800) 968-1363  
 

Taylor Thermometer 5109 User Manual
Toshiba Network Router A305 User Manual
U Line Refrigerator U 2275ZWCOL 00 User Manual
Uniflame Gas Grill CBC940WD C User Manual
Universal Power Group Automobile Parts Consumer Battery Solutions User Manual
Valcom Battery Charger VPB 260 User Manual
Venturer Portable DVD Player GB 1 User Manual
Vivitek Projector D86X User Manual
Vulcan Hart Oven VB 21 ML 052312 User Manual
Wagner SprayTech Paint Sprayer 558021 User Manual